Monday, October 14, 2013

Pressure Measurements Using Different Devices

Abstract: The purpose of this experiment was to utilize a Bourden Gage, a U-tube manometer and a body of water piezometer to analyze the behavior of a remains placed under force per building clog bea, and to test the validity of the hydrostatic cart par. In assign to accomplish these ends, the fluids within the scheme (air, water and mercury) must be considered incompressible. Experimental data upholds the validity of the hydrostatic hug equation, as both the manometer and piezometer displayed a direct relationship between system pressing and fluid height. An analysis of percent wrongful conduct revealed a discrepancy between the accuracy of the manometer and piezometer. At low pressure, the manometer displayed a 100% error, which trailed off smoothly to a final range of 31% at high pressure. The piezometer, on the other hand, only if fluctuated up and down between 0 and 10% error with no relationship to the pressure level. This could be evidence of a sma ll leak in the manometer which causes a fixed pressure drop, causing a greater percent difference at lower pressures than at higher pressures. launch and Objective:   twitch is a measure of force exerted per unit area.  In rig to use the principles of fluid statics to analyze pressure in a system, it is helpful to make several assumptions.
Ordercustompaper.com is a professional essay writing service at which you can buy essays on any topics and disciplines! All custom essays are written by professional writers!
 Fluids are take for minded(p) to be incompressible, in other words, they occupy a constant quantity volume and maintain a constant parsimony throughout the experiment.  Pressure on a fluid at slackening is assumed to be isotropic at every bakshis, which is infall ible to satisfy the zero sum force dimensio! n at a disposed point.  In addition, pressure is assumed to be exerted normal to the contact surfaces at the boundaries of the system.  Pressure in a given system is governed by the following equation: P = ?gh = ?h (Eq. 1) where ? is density, g is the gravitational acceleration constant, P is the pressure and h is the height at any given point in the fluid.  Alternatively, the specific gravity (?) of...If you want to go about(predicate) a full essay, order it on our website: OrderCustomPaper.com

If you want to get a full essay, visit our page: write my paper

No comments:

Post a Comment